Downloading ethernet driver device won start code 10

 · Disconnect the ethernet cable from the ethernet port of the computer that is affected by the error (if not done already). Travel to bltadwin.ru; download the Intel Ethernet Connections Utility. I use the "bltadwin.ru" file, not the tar.  · Start, control panel, device manager, network, right click on the adapter and make sure it's enabled there. If so, then try deleting it, then restart your computer. Windows should install it and correct the issue if there was a problem. Make a system restore point first in case this doesn't work. Rick.  · Usually, a Code 10 error is a temporary error, generated when Device Manager can't start the hardware device. However this error is considered a generic message indicating an unspecified problem. This most commonly occurs after running a Windows* .

At this point, if you're still seeing code 10, it's likely that you have a faulty device. If possible, try connecting the hardware to another computer and seeing if it works at all. If it doesn't work on another system, then you should contact the manufacturer or replace the device. Fix 2: Power cycle your PC. Sometimes the nonworking network adapter can be fixed by power cycling your PC, which is mainly about shutting down your PC and then disconnecting it from the power source before you turn it back on bltadwin.ru is often used to refresh our Internet connection and hopefully fix our network adapter not working/responding issue. A 1G SFP was inserted in it so the NIC didn't start. So it proves that it will work only in 10G mode and not 1G / 10G mode. Marked as answer by Srijit B Friday, PM.

Right-click on My Computer. Click Properties Hardware menu tab Device Manager. Double-click the device that is causing the error (there will be a yellow triangle with exclamation mark to the left of it) Right-click the specific device and select Properties. Click on the Driver menu tab and select Update Driver. If it's a card, remove it through Device Manager, shut down, remove the physical card, reboot, check that it's gone, shut down, re-install and bltadwin.ru the intel driver, if not repeat and try the Broadcom. From what I could see these may be the networking options: Integrated Realtek C 10/ Fast Ethernet Network Connection. The Code 10 error is one of several Device Manager error codes. It's generated when Device Manager can't start the hardware device, a situation usually caused by outdated or corrupted drivers. A device may also receive a Code 10 error if a driver generates an error that Device Manager doesn't understand.